When the application has stopped after arriving at a breakpoint, you can select Debug -> Go to start the application running again. When the application is running, select Debug -> Stop to stop the application.

You may not get an immediate response to the stop if the application is not currently executing an action statement. As described in Section 3.4, under single-stepping you will only get a response from the application when it is executing action statements.

Tutorial

Bring the application to the foreground by selecting Debug -> Show application.

1.In the application, select Stuff -> Timeout loop.

2.In QuikStep, select Debug -> Stop.

3.The application stops in the response to item Timeoutloop_MC.

4.Set the value of Foo_IV to 2 so the loop will end right away.

5.Select Debug ➤ Go to restart here.